Monday, March 9, 2015

What are all the parameters accounted for "Pressure Gauge" Specification/Data Sheet?

What are all the parameters accounted for "Pressure Gauge" Specification/Data Sheet?

The following parameters to be considered/accounted while preparing the Specification Sheet or Datasheet of "PRESSURE GAUGE"

  1. TAG No.
  2. Service
  3. P&ID No.
  4. Technical Specification ( Technical Specification - Instrumentation provided by Client)
  5. Line/Equipment No.
  6. Hazardous Area Classification
  7. Ingress Protection
  8. Pressure Measurement Type (Direct/Remote)
  9. Pressure Element/Material
  10. Figure Interval (from Vendor)
  11. Minor Graduation (from Vendor)
  12. Accuracy
  13. Case Design/Case Size
  14. Case/Lens/Movement Material
  15. Ring Construction/Material
  16. Dial Material/Color
  17. Pointer Material/Color
  18. Filled Case/Fluid
  19. Mounting
  20. Wetted Parts Material
  21. Process Connection Size
  22. Sour Service Specification (NACE requirement)
  23. Syphon Requirement
  24. Over range protection
  25. Snubber Gauge Saver 
  26. Movement Damping Material
  27. Zero Reset
  28. Blowout protection
  29. Full Vacuum protection
  30. Manifold requirement
Apart from the above listed, we need to get the process condition i.e process parameters from the "PROCESS" discipline as listed below

  1. Fluid / Fluid State
  2. Design Pressure Min/Max
  3. Operating Pressure Min/Max
  4. Design Temperature Min/Max
  5. Operating Temperature Min/Max
With all the above Information one can prepare the Pressure Gauge Datasheet/Specification sheet.
Please note that all the above parameters are accounted as project experience. In addition to the above one need to follow the "Project Specification recommended"

Will write what are all the parameters to be taken/accounted if we go for "DIAPHRAGM SEAL" Pressure gauge in NEXT post.

Please write to ogtechengineering@gmail.com for any observations.

Thanks


No comments:

Post a Comment